i put this in the uno section as well..

https://www.fiatforum.com/uno-technical/96940-free-uno-1litre-ie-gearbox-5-speed-must-go.html

i would MUCH rather it went to a fiat lover than the tip.
so its free.
post code OL14
todmorden. west yorks.

thanks

aran.

Did Steve not want one of these? does it def fit the panda.

well i know it goes onto the fire block fine.
its got a hydro clutch though. but injection panda might have this ??
the gear linkage is different. but a scrap uno would do fine.

aran.

Gearbox from 93 Uno will be a 514, gearbox on later Panda's is the 526. Both having the FIRE type engine, the Uno box would fit a Panda engine but there is no guarantee that the cable linkages will be interchangeable. The 514 box also used a specific clutch kit so no guarantees there either.

Also, the 514 used an hydraulic clutch, so the gearbox end is set up for a slave cylinder rather than a cable. Did the late Panda's use hydraulic or a cable?

Sorry if I am raining on anyone's parade.
Rgds.

Better to know than not Pete. Usefull knowledge as always :worship:

petel said:

Did the late Panda's use hydraulic or a cable?

Click to expand...

They use a cable, they are high tech with their ecu's and servo's but not that high tech

Thanks Panda-Sport.
Rgds.

Yep my '94 is cable driven too.

I was after a 5 speed box for Splutter, but since I picked up the 5 speed CLX I am leaving Splutter as he is.

arr well, now we know..
lets hope some one from the uno forum will use it.

aran.

Xsisley said:

arr well, now we know..
lets hope some one from the uno forum will use it.

aran.

Click to expand...

I suspect that the hydraulic clutch type gearbox from a mk2 Uno is the Punto/ Tipo derived gearbox? If a picture can be shown of it, it can be compared with a later Panda 'box. You might well find that the clutch lever can be swapped over in place of the hydraulic clutch cylinder, as can some of the selector rods. Worth a look I suppose?

The gearbox is no good to me I'm afraid as A: I'm miles away and B: my Uno uses the earlier (non Tipo/ Punto) cable clutch gearbox.

Hope it goes to a good home nonetheless!

1986Uno45S said:

You might well find that the clutch lever can be swapped over in place of the hydraulic clutch cylinder, as can some of the selector rods. Worth a look I suppose?

Hope it goes to a good home nonetheless!

Click to expand...

looking at it, it does look as if it could be swapped to cable driven, and the selector rods too.

thought some of you might like to see this FIRE engine in bits...
i think everything is there except the inlet manifold / carb airbox.



aran.