Hi again,
I've picked up a cherry 2000 Panda, thats been crashed on the front right, passenger side.
I would like to replace the outer fender, inner fender, "bridge" or nose, but I want to do a real clean job, as the car is as new. This'll be my keeper
I was thinking the correct way would be to use a spot weld cutter to cut out the welds carefully. from both the "new" car and the donor car which has solid front but rotted floors...
Or, does anyone have an aftermarket source for "quality" sheetmetal?
I would appreciate some feedback from people/pros that have done this
regards,
nikos
I've picked up a cherry 2000 Panda, thats been crashed on the front right, passenger side.
I would like to replace the outer fender, inner fender, "bridge" or nose, but I want to do a real clean job, as the car is as new. This'll be my keeper
I was thinking the correct way would be to use a spot weld cutter to cut out the welds carefully. from both the "new" car and the donor car which has solid front but rotted floors...
Or, does anyone have an aftermarket source for "quality" sheetmetal?
I would appreciate some feedback from people/pros that have done this
regards,
nikos