FreedomWon
New member
- Joined
- Jan 29, 2015
- Messages
- 1
- Points
- 1
Hi Fiat lovers
I am converting a 2010 Fiat 500 1,2 to electric drive in South Africa. It is looking awesome but I have two technical challenges that I am hoping some good folk can help me with.
1) I want to use the original electronic accelerator pedal to control my motor controller. Can anyone send me the pin configuration and internal circuitry of the pedal and the wires going into it from the car? It has six pins on it labelled A, B , C, D and F.
2) I also want to use the original fuel quantity display but I need to know what I must put on the wires that went to the old fuel sender to get the proper range i.e. is it a voltage range? Is the sender simply a resistor?
I look forward to hearing from some of those more tech savvy people out there.
Cheers
Antony
I am converting a 2010 Fiat 500 1,2 to electric drive in South Africa. It is looking awesome but I have two technical challenges that I am hoping some good folk can help me with.
1) I want to use the original electronic accelerator pedal to control my motor controller. Can anyone send me the pin configuration and internal circuitry of the pedal and the wires going into it from the car? It has six pins on it labelled A, B , C, D and F.
2) I also want to use the original fuel quantity display but I need to know what I must put on the wires that went to the old fuel sender to get the proper range i.e. is it a voltage range? Is the sender simply a resistor?
I look forward to hearing from some of those more tech savvy people out there.
Cheers
Antony