IMG_20120425_145937.jpg

Panda (Classic) John Dragon Man's 4x4 Sisley

Introduction

Hello!

Well, I have been waiting a long time to do this!

Introducing (Drum roll please!).....

Edit: about half way through the time it took me to get the car on the road it found the name Talon. So everyone Meet:
Talon. My Fiat Panda 4x4 Sisley:

attachment.php

attachment.php

attachment.php


Great Looking car.. As i am sure you all agree!

It has its Good points:

No Horrid noises in any gear and the 4x4 system works and sounds brilliant! Its a Sisley! And it came with some nice extras such as the light grill covers.

and also nice low mileage.
attachment.php



And it has its bad points... Lots of bad points:

Mid body rust, This is the worst on the drivers side (in the UK) front wing:
attachment.php


The Doors are Rusty.. Ok, i did expect this as it seems to be a common thing on most Fiats over 10-15 years old:
attachment.php



And the other Door, Not as bad.. I may be able to save this side!
attachment.php


"Phantom Electronics" the electronics do what they want to do, when they want to do it. No Switches necessary!

Also the Fuse box now lives here :( That means that a flap has been cut in the pocket :(
attachment.php


The Exhaust is very broken, in multiple parts. even the down pipe!
attachment.php


Lastly and by far the worst, Under body rust. Now its not as bad as it could be. The rear sills on both sides have a small 1 - 2 inch hole in them. No biggy.
I have still yet to remove all the plastic wheel arch liners and have a proper look.
Here's a picture from the front drivers side wheel arch, its only a skin so a easy repair:
attachment.php


A bit of work needs doing to the brakes, pads i think. The fluid needs changing and the drivers side front brake pipe is corroded so i will replace that.

Also the engine needs a good cleaning up, a full on service replacing the water pump, cam belt, tensioner pulley, distributor cap and rotor arm, filters, oil, radiator, coolant and starter motor.

I also need a few things like a locking filler cap, the little clips that hold the air box together, a new boot gas strut and a non damaged back bumper.

Its the car I have always wanted right from when I was a young lad. So you can imagine how I was when I won it on eBay for a grand total of £547. Getting it from Wales To my home town of Derby Cost me £135.

With some love, care and late nights I reckon I can turn it into a cracking motor!

Oh and stay tuned as I will be keeping a Video Log of what I will be doing to the car on Youtube!

This is the video i took just as the car transporter left from delivering it:




See the rest of the videos Here: Fiat Panda 4x4 Sisley Restoration Video Logs

See my Youtube Channel >>>Here<<<

Also Click Here for more up to date pictures of this car!

I am so very proud to be the owner of a Fiat Panda 4x4 Sisley!

:D:D:D


Edit: this is how Talon looks now:



:eek::cool::cool::cool::yum:

Since then Talon has gained more lights, and now has some blue rust free Seat Marbella doors. I had also converted him to Fuel injection, however the parts i used were old and worn so now it is back on Carburettor.

This thread has its ups and downs but through the years Talon and myself have pulled through.

When you are done reading this thread, be sure to check out the little red scrap yard rescued Seat Marbella thread and also Project Fallout!

Peace all and enjoy the thread, videos and pictures!
If that's the sort of thing you're after why not try a pair of Seat Terra mirrors....


yes, i do like having good mirrors and them Terra mirrors look like they would fit the bill.

now, anybody know where i can get them from? 2nd hand or new.. not fussed..

I think there's a pair on some knackered old Terra van down near Alton - I'll take a screwdriver next time I'm down there! :devil:
 
playing around with a seicento rev counter.. soon found a problem though :(



2 ignition coils.. the rev counter reads twice what the engine is actualy doing! guhh.... oh well..

edit:

Just found that annoying bolt i thought i'd lost! so just this second put that in!

Edit 2!:

MOT required job list:

fix the front wiper and get a new blade
waxyol pass. sill
fill up both washer bottles
swap doors over when i get them
fit mirrors to doors, when i get them
swap tyres over when i get them
 
Last edited:
well bit of an update, i have remembered more things to do on my job list.

http://www.facebook.com/john.the.dragon.man/posts/10151056125824743

List of jobs left to do on my car..

Important (MOT required) Jobs to do:

fit/tighten exhaust manifold nuts + 1 washer
fix the front wiper and get a new blade
waxyol pass. sill
fill up both washer bottles
swap doors over when i get them
fit mirrors to doors, when i get them
swap wheels over for good ones when i get them

Non Important (non MOT required) Jobs to do:

add plastic trim to wheel arches
acquire dash screws, screw in ALL the screws!
underseal under prop shaft mounts
Grease prop shaft CVs (not bad but may as well do them)
paint rear drums
get all rusty things shock blasted. (4x4 rims, sump guard, light grills, maybe bull bars)
paint rims white, fit new tyres (145/80 R13) and fit to car
paint and fit sump guard
repair light grills after shock blasted then paint (or plastic coat?), fit to car
paint (or plastic coat?) and fit bull bars
get the new doors colour matched with the car

i could do the important jobs real quick if i had all the bits here but meh, im in no rush lol

ok, the sill job is not an MOT requirement but i want it done before i take it in!

Edit: i have updated my Wanted thread.. if anybody could help me out i would be very grateful!
 
Last edited:
well guys and girls i am back from my 2 week break.

so today i have been working on my car.

the sills are both waxyoled,
exhaust manifold nuts are all torqued up
fitted some more plastic trim items inside the car (rear ash tray and other things)

and

the best bit

i have fixed my wiper and converted it to a bolt on spline.

theres a video to follow but i need to grab it off my camera and edit it all together, then upload it.

every day my list is getting smaller.

looking forward to MITcar! hope your coming up to it Mr. purple haze ;)
if you are and can fit a certain item in your car as well i can get my car up on axle stands strip all the rims and send Everything (inducing the certain item) off to be shock blasted!

i am stocking up on satin black spray paint LoL!
 
ooo that sounds interesting. you got another? hehe

yeah find out and tell me man, ill send payment right over.
you dont happen to have 4 long bolts that will hold a sump guard on and a bull bar on at the same time do you?
ive searched and searched for ones that will fit and hold both on, but i cant find anything.

anyhoo enough about that. now for something every panda owner will want to see...

the wiper spline repair job! (in High Deff too, get some popcorn guys! :))

 
Last edited:
ooo that sounds interesting. you got another? hehe
Yeah loads, take your pick! :)

No sump guard bolts though, now you can appreciate why I have special clamps made up for mine. Can sell you set of those if you like.
 
Back
Top