This is my guide to fitting a Novitec bumper for the Seicento.

DON'T DO IT!!

F'Kin nightmare, Had to cut off a massive strip of fibreglass to make it fit, Drill holes for the bolts, well at least its on and it looks nice, euro stylee with DTM flaps on the bottom
And i'm the only person in the UK to have one na na na na na

This is the bumper below, but its in black


See you later, off to the Pub (Guiness Extra Cold's calling me)

"The Not so Fast but Furious"

where did you have to cut it?

where are the pics???

No pics mate
I had to cut a lip off the top approx 1" and cut out a groove in the middle to fit it round a support strut.
Took six hours to do but i'm pleased with it.
Just need a MPI shape towing eye cover to finish it off as the SPI are totally different.
Hav'nt fitted my Shark roof spoiler yet, looks a bit err sort of pants

"The Not so Fast but Furious"

i want this bumper
i saw it ages ago on their site and adored it ever since
you not recommend fitting it urself then
hmm damn
i was very tempted by it.
I like a lot of the stuff novitec do. I definately like the front corner splitters and eye brows.

when do you think you have some piccies of this new install then? oh and the 6x9 in the rear?

nice one cento

joe turner

Seicento Sporting 2000 X
Black
Black Front and Side Indicaters
JBL ICE + Pioneer DCEH8400 HeadUnit 6x9 in parcel shelf,16.5cm in rear arm rests, 10cm in front)
Abarth badges all round from abarthbadges.co.uk

Errr dunno on the pics mate still hav'nt bought a digital camera spent it all on mods , but i will be on the ClubCento stand at www.donnyshow.co.uk next weekend, if anyones going your welcome to come and have a look.

If your compitent enough you can fit it yourself but if you want if 100% perfect get a bodyshop to fit it.
To make it fit you have to:
1- Trim a piece of fibreglass off the top
2- Cut out a notch for a support strut
3- Drill four holes for the bolts, Where it mounts onto the wings a right pain in the arse to do as its very difficult to make them line up 100%
4- Take out the front bolt holding in the wings in for clearence
5- Fit the clear indicators provided

Job done, at first i was'nt to sure about it but its growing on me, coz my Sei's on 15's it looks a high, as in the pic above.

"The Not so Fast but Furious"

Oh and theres now just enough space between the the bonnet catch and bonnet for a 9" Neon
Mmmmmmmm Nightrider stylee [8D]

"The Not so Fast but Furious"

Oh and theres now a gap between the bumper and bonnet so theres loads of air rushing into your engine, no need for a length of piping to your induction kit

"The Not so Fast but Furious"

Very nice bumper!
I'll be at Donny on the Saturday so i'll come and say hi if i see you.

Si.
2.0 20v HGT + Superchip + NOS