Guides by sludgeguts

Tools needed - crosshead screwdriver, 10mm socket, 17mm socket & #4 hex bit. Open the fuel flap & remove the locking fuel cap. Remove the two screws holding the fuel flap in place - the lower one (on mine) was put in at a bad angle, making removal slightly awkward. From the boot...

If you want to include the fog light & only run 2 core cable, it is best to bring the trailer cable into the OSR (driver's side)(there is a handy drain hole where two bits of bodywork join) . I brought mine into the NSR (passenger) & so had to run the three core cable. Anyway. For those who are...

I wanted to run a bit of wire into the engine bay so I could use a solar panel to charge my battery during the day - as the power sockets only work off the ignition! A search of the forum brought up a brief description so off I went to look for myself based on the description. In the passenger...

Firstly, make sure to crack the seal on the wheel bolts. Handbrake on and put the engine in gear. Using the appropriate tool, ensure all the bolts securing the wheel have been released. Secondly, jack up the car and support on an axle stand or similar appropriate device. Thirdly, remove the...