Guides by s and b

Panda 2012+ rear cluster removal
s and b
1.00 star(s) Difficulty rating
Views
2,324
undo the two 10mm bolts grab the complete rear light cluster pull it backwards away from the car until the 2 clips near the window glass release beware the one ive just done was the tightest rear light ive ever removed the fiat handbook is not clear on this so beware
s and b
Updated
4.00 star(s) Difficulty rating
Views
2,571
opened door it dropped a little bit opened door a gain it fell off (did i buy coco the clowns ex demonstrator?) very heavy doors these it would at the least smash a toe if it dropped on you as you opened it i took the door off 2 10 mm headed bolts in hinges wiring loom grey clip lifted up...
Punto (Mk2/2b) underbonnet fan relay
s and b
1.00 star(s) Difficulty rating
Views
7,955
warning warning warning (aka smith family robinson) i always check the fans by hardwiring them to the battery but as i had the time i plugged the laptop in looking for previous fault codes (see blue crosses in photo for fuse and relay location) relay clicked and seemed to work but had...
Punto (Mk2/2b) MK2B STEREO WIRING HELP
s and b
Updated
1.00 star(s) Difficulty rating
Views
13,125
There is only one full time live in a mk2b punto at the stereo loom and its constantly live so even with key in your pocket its still pumping volts, ie your radio runs the risk of flattening the battery over a period of car non use or worse some car stereos get very hot if left with permanent...
Punto (Mk1) standard drum removal
s and b
2.00 star(s) Difficulty rating
Views
4,643
these often refuse to come off because there develops a wear lip on the edge of the drum however if you look at the wheel locating pegs you will notice that these screw into the hub only as the hub has a larger more course thread in it now the clever bit go to a scrappy to the vauxhall bit and...
s and b
Updated
1.00 star(s) Difficulty rating
Views
12,091
First off, remove the road wheel, don't struggle trying to work round it. Always support vehicle with an axle stand and not just the jack. - Wiggle a wire brush in the phillips heads to remove crud before attempting to undo. - Use a good quality unworn well fitting screwdriver - If stuck try...
Back
Top