torniojaws
New member
- Joined
- May 4, 2019
- Messages
- 137
- Points
- 40
So, I installed a new H4 highlight beam, which works just fine, but is currently held in place by a wad of paper 
The reason being, the retaining hook seems to have snapped (circled in red in the pic).
Does anyone have some good tricks on how to get the retaining clip to stay without the hook? I think I might upgrade to a ball of duct tape during the weekend, in case the backside gets hot and could heat up the paper
Right now it is basically:
[ O 0-=>
So, the plastic/rubber(?) cap, a ball of paper, and the plastic wiring thingy.
The reason being, the retaining hook seems to have snapped (circled in red in the pic).Does anyone have some good tricks on how to get the retaining clip to stay without the hook? I think I might upgrade to a ball of duct tape during the weekend, in case the backside gets hot and could heat up the paper
Right now it is basically:
[ O 0-=>
So, the plastic/rubber(?) cap, a ball of paper, and the plastic wiring thingy.
Attachments
Last edited:
