Technical Third Gear Problem... new gearbox!?

Currently reading:
Technical Third Gear Problem... new gearbox!?

Joined
May 6, 2008
Messages
294
Points
55
Location
Norfolk
I have a Fiat Grande Punto 1.4 Active Sport 2006.
Recently when I've been driving my car, t t struggles to go into third gear and always grinds. Sometimes it doesn't happen and goes in just fine. However third gear is the only one effected.

I'm not sure if I need my gear box replacing or new bearings?

I've searched the forum and couldn't see that it was a common fault especially it not being the 1.9 Multijet!!

Just wondered if anyone else could shed a little bit of light on the situation?! And had the same problems. The car done low mileage and isn't used alot.

Thanks in advance
 
Third gear synchro is worn out..Will need a bulk ring , synchro and sleeve ..If you had the parts and someone with knowledge of gearboxes ,could be done in a day
 
the 1.9 gearbox isnt that bad!! :p

On my old 1.2 GP (same box as you) my 3rd's synco went, I actually found it cheaper to get a reconditioned box off punto spares off ebay (see his website, always gives good advice) it was about £250, I got a new clutch to go with it and with labour from a 'vat free' garage I payed 350 in total.

A last ditch effort could be some new box oil, i dont know what the viscosity is on your gearbox but I would definitely try fuchs sintofluid
 
Visit a fiat specialist (this is the critical part lol) and check cables / replace oil with a good one...
Also this can be a clutch related problem.
 
Back
Top