Hello,

I'm having difficulty unclipping the lambda sensor on my grande punto.

I expected it to be a case of sliding the yellow piece until it clicks, but the sensor wont pop out. Am I missing something staring me in the face?


I have a photo, if that helps.


Thank you in advance

Lambda Sensor unscrews from the exhaust, its not clipped in.

Thanks for your reply, but I'm referring to the sensor's connector, which is attached to the sensor by 4 wires, rather than the sensor itself.

It's a sort of plug set up.


Any ideas? Thanks again

Done it.

I slid the yellow piece outwards until it clicked. I then took a small screw driver, poked it under the black plastic arch on the non-removable part (might have a serial number on it) and pushed up a little black hook with the end of the screwdriver, which had been holding the two pieces together.

Thought I'd mention this in case somebody else needs an answer at some point.