Styling Footwell lights

Currently reading:
Styling Footwell lights

Joined
Jul 25, 2006
Messages
507
Points
121
Location
York
I have got some LED strips to go in the front footwells and was wondering if anyone knew where I could join the cable to. I want to do them off the interior light and would be able to follow the cable down the pillar and into the dash and connect there, but am just wondering if anyone knew where the cable was so I don't have to take the trim off to work out where it goes.

Thanks in advance.

Alex
 
sounds abit dodgy to me, i wouldn't even tink about touching the electrics, could cause all sorts of faults in the future.
 
wire in parallel to the wires behind the courtesy light (if you have a sporting the wiring is quite complex cos of 2 bulbs and lots of switch positions). Not tried it but there is no reason why that wont work. Im sure you could feed it down from there without having to remove any trim. Just takes some niffty tucking.
 
wire in parallel to the wires behind the courtesy light (if you have a sporting the wiring is quite complex cos of 2 bulbs and lots of switch positions). Not tried it but there is no reason why that wont work. Im sure you could feed it down from there without having to remove any trim. Just takes some niffty tucking.

What makes you think that only the Sporting has "2 bulbs & lots of switch positions"?
 
it does have 2 bulbs, i took the light appart last night to see what type of buls were in there, there are two switches (one left, one right) each with 3 positions. To get them both on always you switch the left one on, to get the right one only you switch the right switch while the left is switched, to get the left you have to switch the left and the right, to get them both on auto you switch them both to the middle and so on. As i said, rather complex ( i probably got those combinations wrong). If you were going to wire a light off it you would have to chose which bulb you wanted it to run off i guess.
 
it does have 2 bulbs, i took the light appart last night to see what type of buls were in there, there are two switches (one left, one right) each with 3 positions. To get them both on always you switch the left one on, to get the right one only you switch the right switch while the left is switched, to get the left you have to switch the left and the right, to get them both on auto you switch them both to the middle and so on. As i said, rather complex ( i probably got those combinations wrong). If you were going to wire a light off it you would have to chose which bulb you wanted it to run off i guess.

I didn't say yours didn't have two bulbs. I said what makes you think that only Sportings have them. As far as I know all G.P.'s have the dual light set up.:cool:
 
Last edited:
lol not negative comments, we were just saying that we wouldn't do it to our GP, as if a fault occured you can say bye bye to your warranty, electronics is a dodgy area to be fidling with, unless you know what you are doing of coarse.
 
tbh if you screw up the wiring by wiring LEDs to the interior i dont think you should touch anything electronic...ever lol
nice to hear you got it done (y) post some piccys up so i can convince my mate to get them in his gp :D
 
Here are a few pics, and a quick video to show how the lights dim when opening and closing the car.

lights1.jpg

lights2.jpg

lights3.jpg


Fading Lights
 
Last edited:
Back
Top