Technical Mass airflow sensor

Currently reading:
Technical Mass airflow sensor

Here is the bracket
You would use the clip on your filter to pass through clip then do it up as normal
I presume you could knock up a bracket as I did IMG_20201023_131527.jpeg
 
Here's a pic of my 80PS diesel engine bay... (Euro 6)

Can't see where the RH air inlet pipe goes, probably somewhere 'cooler' down below the exhaust manifold..

IMG_5452.jpg

R-V-M

Here is what I mean by that "flimsy" plastic... My filter box is very similar to this picture and there is little film of dust inside the pipes after the filter.

Another reason also take a look at the filter picture above, that dirty part is where it sucks the air to the box.

It's much better design on the newer Multijet II's however.
 
Yeah I'm leaving the cover on, mainly because it has part of the breather tube built into it. I could fit a hose to connect the breather pipe at the back to the intake, but I thought the engine cover/filter box and the foam piece between the box and the engine would help dampen engine noise.
I have a video clip of the turbo, but can't figure out how to upload on here.
 
Back
Top