Hi all
I have received a new Fuel pressure sensor, pressure valve and Diesel flow regulator.
The elearn guide says just loose the fuel tank cap, and start replacing. But I cannot find the bleeding procedure anywhere?
The Pressure sensor comes with big warning that no air must exist in the system when starting up. I assume air could mess up the initial calibration.
Or do i just let it self prime, then afterwords reset the "High pressure fuel" in MultiEcuscan?
Please help
I have received a new Fuel pressure sensor, pressure valve and Diesel flow regulator.
The elearn guide says just loose the fuel tank cap, and start replacing. But I cannot find the bleeding procedure anywhere?
The Pressure sensor comes with big warning that no air must exist in the system when starting up. I assume air could mess up the initial calibration.
Or do i just let it self prime, then afterwords reset the "High pressure fuel" in MultiEcuscan?
Please help