My 2007 Cargo 1.9 sx with 60k clutch became notchy just lately with gear engagement being difficult. On turning a sharp right bend on a hill I noticed the brake dash light flash on so I checked the fluid to find it low. On inspection I noticed the clutch slave cylinder had been sick over the bell housing. A replacement cylinder from Eurocarparts was £42 I had to remove the battery and it case (3 bolts) to access the the slave cylinder which is secured by 2 set bolts. The old unit was made of composite the new cast steel, the hose connection is a push fit held by a C clip (easy) I did clamp the hose to retain fluid . I wrapped the bleed nipple around with a rag then released the clamp after opening the bleed nipple the fluid flowed out blowing the air bubbles with it, sorted easy job.