Hi all

My Doblo (actually a Combo, shhh) is not starting. Ive found the culprit, a loose lead unplugged. Problem is, I cannot find the socket to put it in. Any ideas?

That looks like a EGR plug but if it is it would not usually stop it starting.

Looks like it only has three pins. Hanging down by starter motor and not much lead to go far.

I doubt that the cause of it not starting unless it's for something very important like the crank/cam sensor fuel pressure sensor ect


More the likely it's leftover wire in the room for something not on the car

Starter motor was replaced, and van broke down 10 miles later. There is seemingly an issue with earth now too as lights on dash are dim when key removed.

Jimmals said:

Starter motor was replaced, and van broke down 10 miles later. There is seemingly an issue with earth now too as lights on dash are dim when key removed.

Click to expand...

Did someone else replace the starter?

Jimmals said:

Starter motor was replaced, and van broke down 10 miles later. There is seemingly an issue with earth now too as lights on dash are dim when key removed.

Click to expand...

It looks VERY clean.. so had been plugged somewhere until recently