Doblocargotom
New member
- Joined
- May 13, 2020
- Messages
- 27
- Points
- 7
Iv not scanned them to be honest, ill have a look at that when I get van back from the garage. I'll see if my scanner will do that then update ?
Technical Check running with light yellow warning triangle
- Thread starter Doblocargotom
- Start date
Currently reading:
Technical Check running with light yellow warning triangle
Iv not scanned them to be honest, ill have a look at that when I get van back from the garage. I'll see if my scanner will do that then update ?
Doblocargotom
New member
- Joined
- May 13, 2020
- Messages
- 27
- Points
- 7
On mine I had a brake light bulb go and it cane up with the yellow triangle and check brake light message - if I remember rightly ?
Doblocargotom
New member
- Joined
- May 13, 2020
- Messages
- 27
- Points
- 7
I tried another pair of new side light bulbs today and refit the running lights and connections look clean and like new. I tried my scanner but it doesnt have airbag and abs function. It doesnt have any errors on a basic scan. Is this warning triangle an MOT failure? All lights work fine. Cheers. Tom.
MOT will probably be fine..
You want to try and plug in and communicate with the 'body computer'
That may well have stored codes hinting at what its not happy with
You want to try and plug in and communicate with the 'body computer'
That may well have stored codes hinting at what its not happy with
Try turning the day running lights on and check they both work, if they don't work then there is a fault somewhere.
to clear the drl warning you may have to fix the problem and turn the drl on then off so the computer can tell problem fixed.
If it's like the 500 the side light bulb has twin filaments -one filament is side light the other filament is drl.
to clear the drl warning you may have to fix the problem and turn the drl on then off so the computer can tell problem fixed.
If it's like the 500 the side light bulb has twin filaments -one filament is side light the other filament is drl.
Doblocargotom
New member
- Joined
- May 13, 2020
- Messages
- 27
- Points
- 7
Iv replaced all the bulbs and they all work fine, just the annoying warning triangle ?
Did the bulb holders look 'crispy'?
Some melting could be enough..
My Punto DRLs are single filament.. but @42,000 miles with them on made its mark
Some melting could be enough..
My Punto DRLs are single filament.. but @42,000 miles with them on made its mark
Doblocargotom
New member
- Joined
- May 13, 2020
- Messages
- 27
- Points
- 7
Did the bulb holders look 'crispy'?
Some melting could be enough..
My Punto DRLs are single filament.. but @42,000 miles with them on made its mark
No they look like new, ill have to follow the wires if I can and check them next ?
Your Dobby is a more upmarket one than mine.
Just been out to check, and the DRL failure doesn't show up if the DRL's are switched off.
But on mine, its just a common yellow bulb failure indication - it doesn't show which lamp is out, and I don't have a yellow triangle for anything!
Just been out to check, and the DRL failure doesn't show up if the DRL's are switched off.
But on mine, its just a common yellow bulb failure indication - it doesn't show which lamp is out, and I don't have a yellow triangle for anything!
