Technical multiecuscan

[kennystag]

Hi
I have installed the latestmultiecuscan software, changed the port settings as per instructions. Put the key into activate. When I go to plug in my fiat doblo after selecting the righttabs on the software it trys to connect but says I need differentconnection. I purchased the right connections for my vehicle. http://www.ebay.co.uk/itm/161715574389?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT Can you please help me with this
Many thanks
Kenny

 

[t1tmt]

Which adaptor have you got plugged in, if you are happy port settings are correct then with the elm reader (with the orange and blue sticker) as per the item listing click on scan within multiecuscan and after a few moments should list all the ECU's detected on your Doblo. If that doesn't play ball then recheck the port settings. No harm in auto scanning for adaptors either.

 

[varesecrazy]

F9...settings.

You can test connection in 20 seconds..if thats ok..
Then Scan Devices

 

[t1tmt]

I was thinking it's f9 but I have slept since I last looked at mes.

 

[varesecrazy]

Same here..
F9. 2nd page..scan interfaces

Should show connection..(HIGH LATENCY)
Isnt necessarily a problem.

Kenny..SEARCH will find lots of great threads about setup.

Thats how I got mine to work all those years ago..

 

[portland_bill]

Hi
I have installed the latestmultiecuscan software, changed the port settings as per instructions. Put the key into activate. When I go to plug in my fiat doblo after selecting the righttabs on the software it trys to connect but says I need differentconnection. I purchased the right connections for my vehicle. http://www.ebay.co.uk/itm/161715574389?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT Can you please help me with this
Many thanks
Kenny

I see you've already been directed to my setup instructions. I found it is important to check the computer settings before opening MES.
Plug connection into car and turn ign on.
Check connection settings in Windows Device Manager (From Control Panel)
Then fire up MES, and check settings within that.

 

[varesecrazy]

Id already linked to the 2 x threads that had helped be get my MES up and running several years ago.

Charlie