(T) Torque Settings for 1.3 Diesel

Can anyone help me with the torque settings for the cylinder head & cams on my 1.3 jtd Doblo. Thanks.

this is what I fond in the eLearn for 1.3JTD doblo:


the value is in daNm, the +90 refers to an additional 90 deg turn after reaching the desired torque.
It has 3.8-4.2 daNm, +90 then ++90
da is basically x10 so you are looking at between 38 and 42Nm

So I suspect you torque all of them up to 40Nm in the specific pattern, then add 90 to each in the same pattern and then 90 one more time.

As you can see they give different values for different bolts, if you need them all please let me know and I will add the complete list.
Hope this helps,
Dan

I'll try to add the doblo elearn book to the download section in the weekend, I'll let you know if I'll be able to do than since I'm a new member and might not have access to that and i don't have the time to check it now.
this way you can take a look at the procedure yourself.

I was unable to upload the files to the download section so here is the link from I have them and you can download it yourself. bad news is that it takes about 9h..

http://www.filestube.com/16vBxFSj2nz...ar-org-ua.html

Hi great information Dan on the head torque settings . Would anybody know what the bottom crank pully bolt (left hand thread) and the cam bolt torque setting is .

For the 1.3Mjet? If you tell me the engine I can take a look and see what I can find.

Cheers,
Dan

Yes Dan its the 16v mjet

Speck is as before, da is x10 for the Nm.
Got them from the Panda eLearn since I did not find them in the Doblo, but it's the same engine.

Also from what I've read on the forum, you need timing tools to do this job, otherwise valves will bend and/or rockers will brake!

Hope this is what you where looking for!
Dan

Hi,sorry to jump in, but i am working on a 2008 fiat 500 1.3 diesel and would like to ask if that has a left hand thread on the bottom pulley bolt, its a male torx type head.
Thanks in advance