im getting 2 fault codes poo69 and po180 relating to fuel temp sensor on my 2006 doblo 1.3 multijet anyone any ideas on where and what to replace

Always difficult interpreting fault codes without knowing what problem you have with the vehicle. Also, a fault code does not necessarily mean you have to replace something.

P0069 = Manifold Absolute Pressure Barometric Pressure Correlation

This suggests the signal from the MAP sensor does not correlate to the signal expected by the ECU. Possibly the MAP sensor needs cleaning.

P0180 = Fuel Temperature Sensor A Circuit Malfunction

You need to check the wiring and connectors from the sensor to the ECU. Possibly cleaning the connectors with electrical contact cleaner will cure the problem.

is the connector on the sensor at bottom of the fuel filter?

connectors seem ok on top and bottom of fuel filter cleaned them and fitted new filter. i can clear the codes all seems fine on a first run then after restarting the fault light reappears. the van seems to run fine a little bit of smoke on cold start.Where is the map sensor located

I've never seen a 1.3MJTD but I suspect the MAP sensor is item #6 on this diagram.
.

Re: air cleaner housing

can anyone tell me how to remove the entire air cleaner housing on my 1.3 multijet diesel

either remove the 2 x 10mm bolts holding air flow meter to housing or metal circlip. Also air intake pipe on the front cleaner housing then lift up slightly and pull towards you.

update on map correlation fault code i took out the map sensor give it a good clean as there were dirt deposits on it replaced it but the check engine light has come on again with the same fault could the sensor be faulty or could it be another problem

need to measure the voltage output from the MAP sensor to verify if it is good or not, cleaning it will do little as its a pressure sensor.

i have the same problem and have replaced my MAP sensor and turned the EML off with no luck. the same error code comes up with error code p0234 and p0235 as well now.....clueless...

Welshy.....your codes are different, can you start a new thread and I will answer your question.

T14086 said:

Welshy.....your codes are different, can you start a new thread and I will answer your question.

Click to expand...

I have my own thread if that helps. Much aporeciated