Technical Doblo 1.3 jtd multijet 05

Currently reading:
Technical Doblo 1.3 jtd multijet 05

vantec

New member
Joined
Sep 22, 2008
Messages
2
Points
1
Doblo 1.3 jtd multijet 05 will drive through 1st 2nd and then in 3rd gear at 3000 rpm goes into limp mode, with a flash of the engine management light. scanner shows fault code of "air supply circuit, flow fault." we have changed the MAF sensor and map/ boost sensor but still no change has anyone any ideas as i'm pulling out what little hair i have left.
 
I think you have the same problem with me. Your turbo pressure is going up to 1.5 bar...
 
Doblo 1.3 jtd multijet 05 will drive through 1st 2nd and then in 3rd gear at 3000 rpm goes into limp mode, with a flash of the engine management light. scanner shows fault code of "air supply circuit, flow fault." we have changed the MAF sensor and map/ boost sensor but still no change has anyone any ideas as i'm pulling out what little hair i have left.

You been to garage yet? (its a common fault on these engines)
 
Back
Top