Styling ATS Classics

Currently reading:
Styling ATS Classics

Whiley

Established member
Joined
May 28, 2005
Messages
1,258
Points
298
Location
Reading
Just some info for anyone looking into getting these, rears need to be machined out and spigot rings made in order to get them to fit a fiat (y) (not that ive bought any or anything honest officer) :rolleyes:
 
very random.... the VW central bore is 57.1 (i think) and the fiat one is 58.1, so in theory all four would need to be machined in order to get them to fit, however u wont need spigot rings (or u shouldnt if they get machined properly) as u are increasing the diameter not trying to decrease it.
 
sorry just been on phone to swt again all four are being machined and he said he could supply spigots if needed. i dont pay much attention in the mornings.... i couldve brought a mail order bride from taiwan, then id probably try to fit her as a wheel :nerner:
 
if you stick ats classic into ebay, there is a guy selling them on there that will bore the rims out to what ever you tell him your car is when you buy the wheels.
 
dr_hillmann said:
if you stick ats classic into ebay, there is a guy selling them on there that will bore the rims out to what ever you tell him your car is when you buy the wheels.
That is the guy from South west tyres my good dr! (should be here tomorow yay)
 
Back
Top