ok guys, im needed some help some ppl might know that i have a max'd out i.c.e install but i need to fit harnesses with my buckets soooo..

im look to find this holding point in my car

by the way if you dont know my car this point is covered up with fiberglass

i could do with know measures, or any ideas ppl might have
Thanks

I dont understand what your asking

by the looks of it i dont think there is a pre drilled hole there. so i think the person that did that install made it themself. PM the member and ask them. most people bolt into the floor directly behind the bucket seats.

ive got this



and it goes all up the side of the windows. i just need to know where this hole is so i aint drilling all over the place and reckin it

well the only holes in that region are the ones that hold in the parcel shelf supports and the D shaped clips for the top of the seats.

you not got room down the back of your seats?

yea i have but if i have a crash it will rip it out or bend the seat with it not a good idea

what about the bolt that holds in the top loop of the original seatbelt. if you know where i mean

If you insist on having a harness in a car without a cage, then the angle of the back strap should be sharper than that. I think the top picture shows the harness bolt going into the mounting point for the shoulder strap of the rear lap 'n' diagonal.

If you can't get to the mounts for the rear seat belt lap straps, then put the harness down to the furthest back part you can get to, drill the floor, and put a large thick plate for the eyes to bolt into.

Cheers

D

i was thinking that.

does the movement and stretch in the belt increase the further away the mounting point is?

In short, yes.

Cheers

D