General HT leads ???

Currently reading:
General HT leads ???

simi

New member
Joined
May 22, 2006
Messages
106
Points
29
Location
rotherham
Hello im new on here just got a fiat cinquecento sx 0.9 but it needs some work i havnt had a fiat before and just woundered does anyone know the correct way that the ht leads go on and in what order from the coil as i cant find anything out on the net thanks
 
with the plug outputs 'south' of the coil pack (i.e the bottom), starting from the far left. plug 2,3 then other pack, 1,4

like this: 2,3 1,4

2 been closest to the front of the car, 4 been back

Then i think you can just see the length of each one, but if not here you go:

1-3-4-2

no1 been the timing belt end.

Check this before trying !!! I got this from the haynes cinq book, think its the same for all models, i cant see any differences.

Can someone confirm?
 
is this the one with the 2 coils mine has 1 bellow the other 1 and 2 connecters on each 1 for the ht leads?.
 
does any1 have any pictures of it or can they take one please im abit confused can email me them if you like or post them on here thanks.
 
Last edited:
ok iv pluged them all in tryed to start it nothing not even a missfire. iv checked the 2 connections going to the coils using a test light when i turn the engine over it lights up on both connection iv tryed using the test light on the ht leads and coil nothing lights up ??? but theres power to the coil so this must mean there nakered any thinks it could anything eles or anyone had this problam ???
 
ok i just looked at the crankshaft sensor and the was a bolt missing out of it and it had moved so i put a new bolt in tryed to start it and still no spark or power from the coil but there is to the coil any1 got and idea whats up with it and has any1 had problams like this
 
ok iv ordered a new crank sensor from work should have it for the week end so i will giv it a go and see whats what
 
chris4500uk said:
I thought it was hard to setup the crank sensor??

I dunno

no there is 2 bolts holding it in place 1 of them was missing and had moved out of place. all you need to do is bolt it on there is no gap to set it to so it says on my autodata
 
ok i put a new crank sensor on there is still power to the coils but no spark anyone got any idea whats up with it.
 
Back
Top