Shop4Parts - UK's largest online superstore for FIAT and Alfa Romeo parts

Technical Det3 fit mode sei turbo

Currently reading:
Technical Det3 fit mode sei turbo

M

manulancia

New member
Joined
Mar 31, 2006
Messages
12
Points
6
I have à 1,2 mpi 8v turbo sei with det 3
Ignition table its ok And its sync ok but when i try to connect injectors thé car wont start its overfueling i think i have the good parameters
But How to verify thé pwm1 i think its fautly And stay open m'y injectors:confused:
 
Yes i suppose when i connect the injectors to thé original 8f iaw ECU with ignition by thé det 3 its ok the car start And run but i have no action with injectors Time And i havé 190 cc injectors its not very good when its cold And thé original map sensor Is not bypass :confused:
 
Are you 100% shure you have installed the DET3 as required in the manual?

Have you:
1) Wired the injectors for the DET3 as banks of 2 on Power out#1 and#2 and set to batch fire 1 and 2.
2) Calibrated the coolant sensor.
3) Set up enrichment parameters correctly.
4) Fitted load resistors to the original Ecu injector inputs and any other modifications that will not effect it's running.

You might be able to get a start up calibration file from ecumaster for a fee if you are struggling?
 
Last edited:
Thks for your help
I give you tomorrow my parameters on det3 Fit mode(y)

I havé thé lambda connected do you think its à reason my car wont start on fit mode?:bang:
By
 
Hello parameters on det 3 are ok for ignition
Injectors connecting on Batch fire mode injection divider 2
Coolant sensors calibrated
When i connect injectors i suppose i stay open its overfueling
Résistors ok for cheated thé original Ecu
:bang::bang::bang:
 
cc1 said:
Are you 100% shure you have installed the DET3 as required in the manual?

Have you:
1) Wired the injectors for the DET3 as banks of 2 on Power out#1 and#2 and set to batch fire 1 and 2.
2) Calibrated the coolant sensor.
3) Set up enrichment parameters correctly.
4) Fitted load resistors to the original Ecu injector inputs and any other modifications that will not effect it's running.

You might be able to get a start up calibration file from ecumaster for a fee if you are struggling?
Click to expand...

What resistor did you use?
 
You must log in or register to reply here.

Similar threads

Bill95
Technical Seicento 1.2 8v 75 Turbo conversion
Replies
0
Views
287
Bill95
Bill95
mattde93
  • Question
General Sei rev counter install
Replies
0
Views
396
mattde93
mattde93
W
Technical Seicento engine swap and turbo questions
Replies
0
Views
930
WEB
W
porta
General Cinq/sei rallying
Replies
0
Views
684
porta
porta
R
Technical 🤷🏼‍♂️ 2 different driveshafts they say both fit 🤦‍♂️
Replies
4
Views
429
razza72
R
Back
Top