hi has anyone bike engined a Seicento.
thanks adam

dont be daft

If anyone has, there isnt much internet coverage and/or they arent a member on here

somewhere within the grass tracking scene there will be a bike engined sei

my other half has bought a new car so ive had the hand me down lol.
w reg Seicento abarth so iam gonna cut it up and fit a bike engine, iam just after some ideas. adam

Pretty sure I saw a bike engined Sei grass tracking on Motors TV once. Think it was a busa or R1 enigine.

will be expensive- talking thousands if not will bleed savings dry

Good luck.....but there will be many sceptics. We get a lot of 'dreamers' in this section regarding engine conversions that promise something and never deliver nor hear from again, please dont be another one to go on the dreamer scrapheap.

Keep us informed

twin bike engined, one up front,one in back.

You any good at welding??

ive already got a cbr 1000 engine ive got a vid somewhere when i tested it at work lol.
adam

it wont let me post vids

it says i need 5 posts

ha ha done it it had no exhaust on so it souned like a bubble machine but its a good engine.
adam

You have 5 posts now!

As said, it will be expensive! A couple of places who advertise in in Fat Car and PPC do kits.

like i said, you any good with a welder?

soz should of said iam a fabricator / welder so it shoudnt be no prob to get it in. its just if it will fit in the front with the chain diff. ive made a chain diff with a audi diff but it seems a big unit so i dont no if i could get it to all fit in.
adam

Don't forget, you'll need some sort of transfer box to get a reverse gear. GL with the project

reverse can be achieved with a starter motor on a ring gear on the rear axle

oadamo said:

soz should of said iam a fabricator / welder so it shoudnt be no prob to get it in.

Click to expand...

Thats alright then as a good spaceframe/cage will be needed to be made if your putting the engine at the back as half the floor will be needed to be chopped out

Brooky said:

like i said, you any good with a welder?

Click to expand...

With access to (and the ability to use) MIG and TIG, tube bender, tubing notcher, casting equipment, pattern making, lathe and mill, gear cutting equipment and about 2 years free time, it'd be a peice of ****!

Otherwise, I'm inclined to think that a CBR engine belongs in a bike!

Brooky said:

Thats alright then as a good spaceframe/cage will be needed to be made if your putting the engine at the back as half the floor will be needed to be chopped out

Click to expand...

i was gonna try and get it in the front if i can. but if not in the back but it will be a lot more work.

fingers99 said:

With access to (and the ability to use) MIG and TIG, tube bender, tubing notcher, casting equipment, pattern making, lathe and mill, gear cutting equipment and about 2 years free time, it'd be a peice of ****!

Otherwise, I'm inclined to think that a CBR engine belongs in a bike!

Click to expand...

Maybe you could try contacting these guys - I think this is a bit more extreme than what you're going after, but worth a try anyway: