Technical Wheel Cap Centres/Covers required

Currently reading:
Technical Wheel Cap Centres/Covers required

AMT

New member
Joined
Nov 27, 2011
Messages
52
Points
14
Hi everyone

I'm after the badge on alloy wheel cap centres for a 2008 Bravo. There are serveral designs of alloys, of which mine are the one with silver 20cm 'ish centre caps covering the bolts and have a 5cm red emblem in the middle.

I've in fact got all the centres in good condition, but all 4 emblem badges are missing. The part number for the complete cap is 717659871 for £20 each (offered reduced @ £15 ea) £60 ttl for 4 little badges.

Can anyone recommend replacement badges? I've seen there is a Bulgarian supplied of cheap adhesive badges, but without seeing how the originals look, I don't know what to do.

Is this a common replacement? Any thoughts people?
Thank you
 
Hi everyone

I'm after the badge on alloy wheel cap centres for a 2008 Bravo. There are serveral designs of alloys, of which mine are the one with silver 20cm 'ish centre caps covering the bolts and have a 5cm red emblem in the middle.

I've in fact got all the centres in good condition, but all 4 emblem badges are missing. The part number for the complete cap is 717659871 for £20 each (offered reduced @ £15 ea) £60 ttl for 4 little badges.

Can anyone recommend replacement badges? I've seen there is a Bulgarian supplied of cheap adhesive badges, but without seeing how the originals look, I don't know what to do.

Is this a common replacement? Any thoughts people?
Thank you

Provided the outer and the emblem are seperate, these should work.

http://www.ebay.co.uk/itm/x4-FIAT-A...arParts_SM&hash=item56367040bb#ht_3063wt_1396
 
This post contains affiliate links which may earn a commission at no additional cost to you.
Thanks Ascott

I hadn't searched for the words "Fiat centre caps". I had been looking for wheel badges etc.

Yes, although there are others selling them for £10 inc p&p, so I think thats worth a try.

I'm going to take some photos of the missing centre caps location for examination on this thread. I'm just not sure they'll clip in.
 
Just took some pics of it and measured it. The location measures 50mm x 4mm deep. The ones shown on ebay are much deeper than 4mm. So may have to chop off or try to seperate the emblem from the clips to make it 2-3mm thick.

Anyone else got this wheel cap? Sorry its a bit close up for identification.

 
Back
Top