last time i used a auto drive in car wash my aerial got bent up a bit, no damage just straightened it out when we came out, but not been back since, anyway it needs a good wash again, should i lay the aerial flat or will the spinney brushes pick it up on the way back,
also using one of these machines i found at that time is a excellent way to remove the roof trim if you decide you don't want it lol, did me a favour as it was my next job at the time, and the amount of crud under there was quite shocking, dont really see the point in replacing them, but as writing this i quite like the idea of painting some the same colour as the alloys to refit, where can i get them from?
also using one of these machines i found at that time is a excellent way to remove the roof trim if you decide you don't want it lol, did me a favour as it was my next job at the time, and the amount of crud under there was quite shocking, dont really see the point in replacing them, but as writing this i quite like the idea of painting some the same colour as the alloys to refit, where can i get them from?