Heater light

Currently reading:
Heater light

Nordmead

New member
Joined
Nov 25, 2012
Messages
2
Points
1
Hi everyone, this is my first post so I hope this in the right section :eek:

Basically I read a guide on the forum about how to replace the heater light (the actual light I replaced was the air recirculation and airflow direction light) the only problem I had was as I placed the bulb in the bulb holder, the bottom half of it slipped through the hole, (it was in quite loosely as I didn't apply that much pressure) so I tried to pull it back though with a small screwdriver which ended up badly as the entire thing is now totally through the hole. Any ideas how I can get it back to how it's supposed to be?

Included a picture so you know what I'm talking about :D


EDIT: I forgot to mention it's 57 plate panda if that makes a difference

IMAG0127.jpg
 
Last edited:
what sort of a hook? I may have a paper clip laying around somewhere.. think that would work?
 
Back
Top