Punto-Rich
New member
- Joined
- May 15, 2007
- Messages
- 11
- Points
- 4
Hi there im a newbie to this site, but i am in need of some aid, i recently had a knock and put a dent into my rear offside quarter panel, the main impact zone is under the light but it took the creased the side as well, now ive managed to remove the crease out of the side, but im needing some help in removing the main dent, now i know its on the main structure beam which means i cant get behind it & knock it out, what exactly is possible?? i was thinking about meshing it and filling, will this work?? or should i have a plate welded onto the panel as you would do with smoothing a boot and then fill it over???
its a 1995 N reg mark one
thanks Rich
its a 1995 N reg mark one
thanks Rich