Register Login
Mr FIAT - Your #1 source for vintage car parts
Rate this Entry

Hi do mk1 manual punto drivshafts fit mk1 auto driveshfts

Posted 19-02-2012 at 14:58 by lukepologt

Hi the other day on our way to work we hit a pot hole and the engine mount bolt snapped wich casused the drivers side driveshaft (the longer shaft) to pop out losing the ball bearings that slot in to the cupling closest to the gearbox.
we can find if manual driveshafts will fit or if we remove the circlip and remove the old roller and ball bearing case can we fit a roller and bearings from a manual shaft. please help thanks
Posted in Model Builds, Punto
Views 974 Comments 2 Email Blog Entry
Total Comments 2

Comments

  1. Old Comment
    fingers99's Avatar
    I'd imagine they're indentical. After all, it's an auto clutch, isn't it? But check with ePER.
    permalink
    Posted 19-02-2012 at 15:23 by fingers99 fingers99 is offline
  2. Old Comment
    dave's Avatar
    hi you are still in the wrong place this is a blog spot, tech questions go here http://www.fiatforum.com/punto/

    they are not the same, manual are male at gearbox end auto are female, i might have one in my shed, i'll pm you
    permalink
    Posted 19-02-2012 at 15:35 by dave dave is offline