Yesterday i had a problem with my USB port and i did the old school solution plugging out the negative pole of the battery.The problem resolved but after i plugged in the pole back and started my engine after a few klms i realised that start and stop system doesnt work and board wrote ''start and stop unavailable''.So any suggestions?What do you think the problem is on software?Is the power of battery-is it possible to got low after plugged out&in it-? Or maybe a fuse is destroyed?.The car is FIAT Punto Evo 2011 1.3 start and stop engine

Note:If i put 1st gear and release clutch the engine doesnt switch off but it goes to a start&stop like mode and the screen shows the symbol of the start&stop system

USB ports, Start Stop systems are far too modern for our Barchetta's. I'm sure a helpful Moderator will be along to put your post onto the right model page.
Hope you sort your problems.

Dave-M said:

USB ports, Start Stop systems are far too modern for our Barchetta's. I'm sure a helpful Moderator will be along to put your post onto the right model page.
Hope you sort your problems.

Click to expand...

Hahaha hahaha f*** I am new here

USB port? Start-stop system? What are these strange terms? Lol!

Gosh I can't believe people can't find their start-stop button in their barchettas. Look again, it's there, right next to the 4WD control knob.