Speechless. :yuck:
This post contains affiliate links which may earn a commission at no additional cost to you.
My thoughts exactly. Rims aside it's not been altered much. Could be a good one for someone.Professionally cut springs? I demand to see the spring cutters spring cuttery qualification certificate!
Actually reckon that car might turn out a bit of a bargain for somebody though, could make a good bit of money back by selling those wheels on alone, might end up a close to free Panda!
Those wheels are 4x100 with wobble bolts btw. That was the first question I asked, as it was tempting just for the wheels. That`s if they were Fiat PCD.
Car looks clean but those wheels are too wide upfront , I'm just about going to fit 6" , 7 " looks ridiculous , rears sit bang on IMO .
As far as I was aware the law is no more than 10mm of tread outside the arch , at least it was when I got an ear bending from the plod a few years back.
If you look at picture three, the rear O/S wheel sticks out a fair bit. Looks like it has a different size tire on the other rear wheel? Maybe it`s just the angles the pictures are taken from.