General Fiat 500 TA undertray bolts

Currently reading:
General Fiat 500 TA undertray bolts

fiat500kent

New member
Joined
May 26, 2015
Messages
11
Points
2
So I have one snapped undertray screw and a missing one. (10mm) should be 6 in total ( TA 2012)

Hence the car has an annoying noise as it the end of the tray flapped about. I have strapped it up with cable ties as a temporary fix

https://www.fiatdalys.lt/en/catalog...41001000/ZFA31200000838871/0/0/0/frame-guards

6. SCREW 10 706 924 is the one I need.

Does any have an idea where I will be able to get 2 off these screws from or similar ones?

Many thanks
 
Last edited:
I snapped one on the back passenger side number 6 same as you and the plastic guard has been cable tied up for three years and two nct's later. And I've notice no noise at all as it's on real tight. I had planned to use an easy-out to remove the stripped bolt but never did. I would just go to your local fastener establishment and pick up a new bolt.
 
One of mine wouldn't tighten up, and I foolishly left it.

Got it back from the garage last week, and they'd lost another.

So down to four, but with no problems.

I'd find a nut that fits on your screw, and then find a screw that fits your nut.

I should do myself really, before I'm down to three, and it drops down.

Speaking of fasteners, by the way, make sure your front inner wheel arches have got all their screws, particularly the 3 cross head screws at the front.

Mine didn't and heavy rain forced the liner back onto the tyre, which wore half of it away.

I had to fix it today, and a genuine liner can be expensive.
 
Back
Top