Hi all. My Cat C that was finished has just thrown up an Airbag error and MES throws up a resistance error on the drivers pre tensioner, which I have changed for a used one.
I've run a ampage check on MES and the passenger one which is OK is 2 Ohms and the drivers is 7 Ohms which is obviously throwing up the error and airbag light.
My question is, does any of you very clever people out there know whether this is likely to be an error with the pre-tensioner itself or within the wiring somewhere?
It's a real pain because to remove it, you have to take out the rear seats and side panel again. Grrrr
Thank you as always.
I've run a ampage check on MES and the passenger one which is OK is 2 Ohms and the drivers is 7 Ohms which is obviously throwing up the error and airbag light.
My question is, does any of you very clever people out there know whether this is likely to be an error with the pre-tensioner itself or within the wiring somewhere?
It's a real pain because to remove it, you have to take out the rear seats and side panel again. Grrrr
Thank you as always.