I changed a bulb today in the heater panel, so I thought I would share with you with pictures on how I did it.
Turn all controls to their far left positions - ut electrical tape across all of the dials so they can't move. No need to remove dials.
Using a large headed screwdriver or two, prise from the top and bottom until the unit pops out enough for you to get your fingers behind. Pull it firmly towards you.
Two bulbs are visible, they just pull out, if you can get hold of them. I put a piece of tape over the bulb and gently squeezed with a pair of pliers to get it out.
Push the new bulb in, and then line up, make sure everythings connected and push back into position. Job done.
Turn all controls to their far left positions - ut electrical tape across all of the dials so they can't move. No need to remove dials.
Using a large headed screwdriver or two, prise from the top and bottom until the unit pops out enough for you to get your fingers behind. Pull it firmly towards you.
Two bulbs are visible, they just pull out, if you can get hold of them. I put a piece of tape over the bulb and gently squeezed with a pair of pliers to get it out.
Push the new bulb in, and then line up, make sure everythings connected and push back into position. Job done.