- Joined
- Apr 2, 2009
- Messages
- 23
- Points
- 6
where have people jacket on their fiat cos im doing my calipers tomorrow but cant see a jacking point anywhere
General Jacking points
- Thread starter Hubbabubba
- Start date
Currently reading:
General Jacking points
I think if you look on the sills, there are two arrows indented into the bodywork, but check the handbook first.
:yeahthat:You can find the answer in the handbook... Page 107
:yeahthat:
dont forget to chock the rear wheel's to stop the car accidently rolling off the jack
and double check you are jacking it in the right place as there was an earlier thread about people doing it in the wrong place and crushing their sills
use the jack supplied with the car and fit it where the manual tells you
easy to crush the outer sill if you use a trolley jack
easy to crush the outer sill if you use a trolley jack
trolly jack on the sub frame bolts
Don't forget the axle stands!
Seen a car fall after a jack failure. Would not like to have half my head in the arch looking closely at brakes.
Seen a car fall after a jack failure.
Would not like to have half my head in the arch looking closely at brakes.
Last edited:
:yeahthat:And yer axle stands
Don't forget the axle stands!
Seen a car fall after a jack failure.
:yeahthat: to all of the above. Can never be to safe. Had a Panda roll off the Jack last week. Should have known better. Luckily it rolled off backwards and I wasn't under it at the time (was 30sec earlier though
)Jon.