Anyone has access to (www.500forum.it)?
There is a conversation i am trying to reed regarding oil cooler installation and there must be a picture that unfortunately i can't see. Perhaps someone that is a member can help.
https://www.500forum.it/forum/viewtopic.php?t=21827

gordinir8 said:

Anyone has access to (www.500forum.it)?
There is a conversation i am trying to reed regarding oil cooler installation and there must be a picture that unfortunately i can't see. Perhaps someone that is a member can help.
https://www.500forum.it/forum/viewtopic.php?t=21827

Click to expand...

Thank you very much for this.

I've signed up and registered on the forum. Only stumble was the "I'm not a bot question"


The answer to this is "genitori"

With the use of google chrome and the in-bult translation tool, its a whole new world to explore!

Have fun!


R

I thought you had to pay a membership for this one. Sure it is interesting forum with lot of info. Ofcourse there are some gentleman in here that it's hard to beat their knowledge.

what size grub screw and where can i purchase this grub screw with allen key centre bit or is this is from Italy??

I used M10 X 1.5 25mm long screw, you need to have the same tap to cut the thread. I used loctite to secure it. You can find those grub screws in hardware stores, no need to order or you can use any M10x1.5 hex bolt, instead and then cut the head. If you have access to a big lathe you can thread it and make the 2.3mm hole there so it will be absolute true but it is not necessary. In order to open the hole in the chain cover i put the gear on its position and then put a pencil thought it to mark the center.

is anyone using the oil pump gear plug modification with the 2.5mm hole, as of today and whats the pressure on the filter to oil cooler side

Where about in Australia do you live "SpeedyF1"?---it might be of help to you if we could put you in contact with another Cinquecento owner--there are quite a few in Australia.