cromaamore65
Member
Hi Folks
I am looking for advice on how to separate my old key fob housing so as to be able to insert the innards into my new replacement housing (when it arrives).
I read with interest a previous thread that ran from 2013 to 2018 where the subject matter was touched on but not fully explained.
BrianMcL was the last person to post on the thread back in Feb 18.
As I don't wish to ruin the new housing through ignorance I would like some info on how to separate the key fob and also how to get the new key shaved down to fit in the key slot.
For reference I acquired the new key fob from a source in Germany at a cost of around £18 including pp and I don't think that he had many left, are they getting rare?
Your help would be most appreciated
Regards
I am looking for advice on how to separate my old key fob housing so as to be able to insert the innards into my new replacement housing (when it arrives).
I read with interest a previous thread that ran from 2013 to 2018 where the subject matter was touched on but not fully explained.
BrianMcL was the last person to post on the thread back in Feb 18.
As I don't wish to ruin the new housing through ignorance I would like some info on how to separate the key fob and also how to get the new key shaved down to fit in the key slot.
For reference I acquired the new key fob from a source in Germany at a cost of around £18 including pp and I don't think that he had many left, are they getting rare?
Your help would be most appreciated
Regards