I have just replaced the cylinder head gasket and today put on a new timing belt (104 teeth same as old one) but after lining up the crankshaft and camshaft sprockets as explained in the Haynes manual (arrow A in attached pic), I found that mark on timing belt camshaft end is one tooth away and for this mark to line up with the one on sprocket and to line up the belt and sprocket marks I had to turn camshaft one tooth and like that it lines up with the deep vee on cylinder head (arrow B).
Can anyone clarify this and what I might be doing wrong please?
Kaci
Can anyone clarify this and what I might be doing wrong please?
Kaci