Hello
I own a 2006 grande multijet sporting
In the last couple of days I have replaced the dual mass flywheel with a solid conversion kit.
Whilst doing this I replaced the notoriously weak end shaft bearings whilst doing this I must have accidentally knocked it into forth and off the selector on the turret.
This has caused it to be in forth gear all the time.

Basically I'm asking for advise on whether this will be fixable through the turret ( selector on top the box) or whether I'll need to take the end case of again ?

Thanks in advance
Mac

Just an update in case anyone else has had this problem after doing bearings.
Had the turret out all selectors are perfectly inline however still in forth gear meaning the arm must have fallen of the selector or be misaligned in the box
Pulling the end case of in place hopefully tomorrow to have a look
Mac