Stripping the donor Panda, had her running this morning (engine, gearbox is shot).
Wanted to run her again now to warm her up fully to warm oil so its easier to drain (made the mistake of storing an engine with oil in it in the garage before ).
Goes to start her, and turns over, nothing else. No fuel pump for 5sec at turn of key.
I've been removing parts of the wiring loom from the body but its all in tack as a whole loom, and now the fuel pump has stopped. Any idea's
Changed ECU incase phone sitting on that had blown it, but its still the same :bang:
Wanted to run her again now to warm her up fully to warm oil so its easier to drain (made the mistake of storing an engine with oil in it in the garage before ).
Goes to start her, and turns over, nothing else. No fuel pump for 5sec at turn of key.
I've been removing parts of the wiring loom from the body but its all in tack as a whole loom, and now the fuel pump has stopped. Any idea's
Changed ECU incase phone sitting on that had blown it, but its still the same :bang: