Afternoon all,

Can anybody help me with what the correct size of bleed screw is for front and rear callipers on a 53 plate MW dynamic, JTD 115.

The previous owner was clearly a gorilla judging by how rounded off the previous ones are!

Many thanks,
Thatengineer

If you do a search on brakeparts.co.uk, you should be able to find the information you're looking for under the caliper section.

It's pretty small. If I remember right I use a 6 or 7mm ring spanner. Certainly smaller than 10mm.

Buy stainless steel ones.

http://www.ebay.co.uk/itm/Stainless...125452?hash=item2a46c7cc0c:g:rXsAAOSwT5tWKfHZ

The steel ones get chewed up because they rust, rather than because of ham-fisted mechanics... but then people do round them off, struggling to get them loose... and just refit them..

Dig one out and measure the thread. There are 7mm, 8mm and 10mm out there.


Ralf S.