Hey all. This topic has been covered several times I know but this is a bit of a different request...

Can someone who owns a pair of cam locking tools please send me a scan of their profile?

I can get them machined up for free at work but need the profile to load into the computer.

So basically you'd just need to grab the tools, lay them cam-side down on a scanner, preferably lay a ruler down with them and bolts/pencils/whatever fits through the bolt holes. Then post or send me the jpeg!

Anyone keen? Please make 100% sure that you own the 2.4 Abarth tools before sending them to me. Thanks in advance!!!

Just to bump this request - I'm not trying to be a tight-arse by getting these locks for free, they are just anavailable in New
Zealand and I need them yesterday...

If someone could help out that would be great!

When i get my locking tool set back i can make a picture and measurements for you. I expect too get them back next week, hope you can wait?

I have a set. I am in Oamaru.
I also made a tool to hold the cam pulley steady to undo the screws which has to come off if you are doing water pump.