I did a minor rebuild on my Stilo, JTD 8v, 59kW (piston rings, con rod bearings... ) and after asembly it started fine, but the idle is on 1100rpm, and no throttle response!!!
Of course, the engine fault is ON!

Please help!!!!

What's the fault code

Oh, I'll try to do that tomorow... I think it's because almost all the sensors were disconected... At least I hope so...

Faults:
P0609
P0235
P190
P220

Possible problem? Faulty wire, or bad ground!

Hi,
try and double check you've not cross connected 2 sensor cables,
done it myself, ( only once = label everything now..!!)

Charlie

well... there are no 2 same conectors on the car... At least, I will have an interesting night... What pisses me the most, is a fact that the car runs, and it was driven to my garage, and now it plays on me... And im just a hobby mechanic!

edwin884 said:

Faults:
P0609
P0235
P190
P220

Possible problem? Faulty wire, or bad ground!

Click to expand...

P0609 Control Module VSS Output "B" Malfunction
P0235 Turbocharger Boost Sensor A Circuit Malfunction
P0220 Throttle/Pedal Position Sensor/Switch B Circuit Malfunction
P0190 Fuel Rail Pressure Sensor Circuit Malfunction

looks to me like something connecting all of these... fuse/relay im off to have a look at eLEARN see if i can help any more

looks to me like something connecting all of these... fuse/relay im off to have a look at eLEARN see if i can help any more

You are the 5th that told me the same thing today! ..in Europe..!:slayer:

do you have air con?

Yes! Why?

does it work?
i know on some stilos if you have a throttle valve fault and no working aircon it can be the 5v feed to the A/C Pressure Sensor, they're all fed off the same circuit...

Hmmm... I'll check that!

i personally cant find anything useful on eLEARN but im not that savvy with it if im honest i know #Davren or #Deckchair5 know a bit more about this 5v circuit... i may be mistaken it MAY not apply to the JTDs but unfortuneately i dont know enough about the Diesels to be of much help

Is there any way to reset the ECU? What is PROXI ALINGMENT?

edwin884 said:

Is there any way to reset the ECU? What is PROXI ALINGMENT?

Click to expand...

Proxi alignment is alignment of all the cars ECUs with the body computer which controls them

So basicly, it is some sort of "reseting" the computers?

edwin884 said:

So basicly, it is some sort of "reseting" the computers?

Click to expand...

No... The Proxy Alignment procedure tells the master computer (the Body Computer) which other ECUs are fitted to the car. You should never need to do the PA procedure unless you have fitted a new ECU, or you have removed one from the car.
.

:yeahthat:

Oh! Thank you!

Still nothing... Every sensor, every cable, every connector is checked, and it just wont start...
Timing belt?