Failed two bits on the MOT
Anti Roll Bar linkage ball joint dust cover excessively damaged so that it it no longer prevents the ingress of dirt Nearside Front
For the above I was going to purchase these: http://www.ebay.co.uk/itm/331101526692
Thought that would be a simple cheap fix rather than just buying new seals might as well do the other side at the same time.
Suspension arm has excessive play in a ball joint Offside front
This one though bit stuck here I was thinking about purchasing
http://www.ebay.co.uk/itm/321932364526 or similar
IF I replace this do I need to take the strain out of the springs or would I be no where near it? I'm hoping just like on a car give it a good hit with a hammer, undo nuts/bolts and replace ensuing everything lines up..
IF I'm wrong though shout
Anti Roll Bar linkage ball joint dust cover excessively damaged so that it it no longer prevents the ingress of dirt Nearside Front
For the above I was going to purchase these: http://www.ebay.co.uk/itm/331101526692
Thought that would be a simple cheap fix rather than just buying new seals might as well do the other side at the same time.
Suspension arm has excessive play in a ball joint Offside front
This one though bit stuck here I was thinking about purchasing
http://www.ebay.co.uk/itm/321932364526 or similar
IF I replace this do I need to take the strain out of the springs or would I be no where near it? I'm hoping just like on a car give it a good hit with a hammer, undo nuts/bolts and replace ensuing everything lines up..
IF I'm wrong though shout
This post contains affiliate links which may earn a commission at no additional cost to you.