Hi,
can anyone tell me how to go about replacing a broken sliding door handle on a 2007 model scudo? I have looked through the workshop manuals and taken the interior panel to get at the lock.
Is the only way to drill out the rivets to remove the lock mechanism and replace the exterior handle after that? If so, what size rivets are they as I don't want to drill them out and then not have the right bits to refit afterwards. I measured the rivets exterior at 15-16mm but have no way of telling the shaft size cos I can't see it and it doesn't seem to mention it in the manuals - tho i could be missing something.
If it's possible to change an exterior handle without taking the rivets out that would be much better, but I'm not sure what to do.
I checked out the "2007 sliding door exterior handle" thread (new user, can't post a link) but can't get my head around it tbh
any help much appreciated! Even just the rivet size would help me out!
can anyone tell me how to go about replacing a broken sliding door handle on a 2007 model scudo? I have looked through the workshop manuals and taken the interior panel to get at the lock.
Is the only way to drill out the rivets to remove the lock mechanism and replace the exterior handle after that? If so, what size rivets are they as I don't want to drill them out and then not have the right bits to refit afterwards. I measured the rivets exterior at 15-16mm but have no way of telling the shaft size cos I can't see it and it doesn't seem to mention it in the manuals - tho i could be missing something.
If it's possible to change an exterior handle without taking the rivets out that would be much better, but I'm not sure what to do.
I checked out the "2007 sliding door exterior handle" thread (new user, can't post a link) but can't get my head around it tbh
any help much appreciated! Even just the rivet size would help me out!