Hi all

Have had my 100HP for nearly 3 years and have done all the usual mods; suspension, intake, exhaust and brakes but was wondering if there are any other little things you can that are obvious to miss. Curious to see what you guys have done to your Panda's too!

What did you do to the exhaust?

Fitted a Magneti Marelli straight through centre section and Magneti Marelli back box

One of these with catalyst in front of your exhaust and a remap will make a significant difference.

As stated many times before: No remaps possible on the 100Hp.

gr J

Change the rather embarrassing horn...easy to do if you cut wires to existing horn and leave it in place behind the front panel.

Sticky tyres gets you around corners faster

SPORTPACK50 said:

Change the rather embarrassing horn...easy to do if you cut wires to existing horn and leave it in place behind the front panel.

Click to expand...

Now that I did thank of, fancied getting a proper Italian air horn! Not sure how much room there is with where the horn is located...

Mat ed30 said:

Sticky tyres gets you around corners faster

Click to expand...

That's one thing I did change too, moved to Yokohama S Drive's which are far more suited to the car! Problem with the 100hp is that the tyres are just too small to fit any next level rubber like Advans or Michelins

The100hpGuy said:

Now that I did thank of, fancied getting a proper Italian air horn! Not sure how much room there is with where the horn is located...

Click to expand...

Not enough room there.
Can fit a Stebel Nautilus type horn under the wheelarch though. Sounds properly Italian!

irc said:

Not enough room there.
Can fit a Stebel Nautilus type horn under the wheelarch though. Sounds properly Italian!

Click to expand...

Will definitely give that horn a look! Interesting, very thought of fitting one there

A3jeroen said:

As stated many times before: No remaps possible on the 100Hp.

gr J

Click to expand...

In that case a Lambda shifter (maybe with a wide band sensor) will do the job. It corrects the air fuel ratios so the engine doesn't run weak.

AF-XIED is an example used on bikes, but the controls for a bike engine are the same as a car. It's likely the Lambda sensor wiring connectors are the same as well.

SPORTPACK50 said:

Change the rather embarrassing horn...easy to do if you cut wires to existing horn and leave it in place behind the front panel.

Click to expand...

Nooooo! Horn makes the car. I think it already sounds cheeky and Italian. First time I peeped wife and cracked up....perfect for a 100hp.

ricky the ginger said:

Nooooo! Horn makes the car. I think it already sounds cheeky and Italian. First time I peeped wife and cracked up....perfect for a 100hp.

Click to expand...

I agree, reminds you that you're driving a Panda after all

True, but just not quite right for berating the pimply youth who has just cut you up on a blind bend.
For a start, they will not hear it over the mind-numbing noise from their in-car entertainment system.
And it's much too polite... "Excuse me, you were a bit close to me there..."
rather than
"WATCH WHERE YOU ARE GOING, YOU IGNORANT T***ER", which seems entirely more appropriate.

(Not that I would use the horn for that, as it's against the Highway Code.)