Hi all

Fitting a Magneti Marelli centre pipe and I'm going to need a new gasket for where the manifold joins up with the centre pipe. What type/size is the gasket? As well as the size of bolts [emoji1]

Thanks!

Soak the down pipe studs in wd40 beforehand and prepare for them to put up a fight, gasket is a normal 2" crush gasket and use plenty of fire gum, a lot of owners struggle to get them to seal for more than a few weeks at a time and some are fine.

Thanks Gavv8, the gasket I got was from Fiat which is the thin metal one, should still work

Main dealer part was needed on mine but it was not expensive.

Unmount and support the exhaust back end. Then be sure the flange is correctly aligned before doing up the bolts evenly. Finally rehang the back end.