Hello all,
had my 2007 multijet since last November. In the past few Weeks, I've had the engine warning light on 3 times, but then it's reset after a few hours, so The first couple of times i ignored it. both times seemed to be linked to me using the wrong gear, but the third instance was this morning when i pulled away fast from a junction (again, being in lower gear might explain this.)
Just getting a little worried that there might. be something wrong. Especially as Im taking it down south for a Week of touring.

Any suggestions/advice? Thanks!

Buy a code reader for about a tenner off ebay and download Fiatecu software from here. Could be many things causing the light. Chief suspect would be the EGR but don't get fixated on this without a code or codes.

hi, do you mean this one, as I would like to buy something like this to be a bit more knowledgable about my car rather than just take it to the garage all the time:bang:

http://www.ebay.co.uk/itm/TUNE-ECU-...iagnostic_Tools_Equipment&hash=item53ed8a0fc4

I'd go for a ELM327 myself but there are others
http://www.ebay.co.uk/itm/ELM327-OBD-2-OBDII-V1-5-CAN-BUS-Diagnostic-interface-Scan-Tool-USB-Cable-16PIN-/170870895805?pt=UK_Diagnostic_Tools_Equipment&hash=item27c8b2f4bd

There are bluetooth ones too that you can pair to an android phone and use android torque.
http://www.ebay.co.uk/itm/For-v1-5a...iagnostic_Tools_Equipment&hash=item2a1fd71c9e

I bought this one for my Panda MJ:

http://www.ebay.co.uk/itm/Car-Diagn...iagnostic_Tools_Equipment&hash=item4d02f3c41c

Booklet explains the codes and you can reset the MIL.