57 reg 1.1 Panda Active - anyone any idea/wiring diagram to decide which MAP sensor wires the chip plugs into? Two wires on chip (I know, it's only a resistor) and four wires on the map sensor socket. I take it from the 'instructions' provided with the chip that two socket wires are power feed, it's the other two wires it's supposed to fit into.

please tell me that this isn't a £1.99 resistor chip off ebay!!

+

Not my car, and I didn't buy the chip
The installation instructions mentioning lots of insulating tape didn't inspire me much to start with......

Why turn a perfectly good car to into a probably uninsured potential MOT faulure bag of nails?

It is a 1.1 Panda, it will always be slow!

"Why turn a perfectly good car to into a probably uninsured potential MOT faulure bag of nails?"
Personally I wouldn't have bothered - why bother buying a cheap to run basic car then try to turn it into something it'll never be?
Alloy wheels, window tints, rear spoiler, chrome tailpipe

I know they look on here so I'll not say any more...

it might have to act as a pull up or down resistor on one of the signal lines so will connect to either the power or ground line.

Might work(make it run badly) until the ecu recalibrates itself.

Trimdoner said:

"Why turn a perfectly good car to into a probably uninsured potential MOT faulure bag of nails?"
Personally I wouldn't have bothered - why bother buying a cheap to run basic car then try to turn it into something it'll never be?
Alloy wheels, window tints, rear spoiler, chrome tailpipe

I know they look on here so I'll not say any more...

Click to expand...

The difference with the HP is it is already made like that, you don't have to spend £10,000 on all the mods